Email：support@wybotpool.com Facebook: @WybotPool Website: www.wybotpool.com
Step 1 - Assembling Step 2 - Charging
1 2 3
Insert two screws in
an opposite direction,
and screw tightly to
assemble the included
flipper into the device.
Insert two wipers into
bottom suction door.
Fully assembled.
3m (9.8ft)
4
5
The flipper is brittle, do
not put upside down
when charging.
Insert charger cable into the charging port, and
keep your device at least 3m away from pool.
fully
charged!
Quick Start Guide
Osprey 200 SE
Ensure you’ve turned
off the device, other-
wise, it will beep when
charging.
Fully charge it before
first use.
6
Turn on the device and you
will hear a beep sound.
Put it into the pool within 3
minutes.
The device will alert if it exceeds
3 minutes, then you should
relaunch the device.
bi~ ~bi~ ~
Need to relaunch
the cleaner!
bi bi...bi bi
7
To Next Page
Need help?
General
