WYBOT S2Pro - User Manual

Email：support@wybotpool.com Facebook: @WybotPool Website: www.wybotpool.com
Step 1 -Install the docking station
(Water depth shall be at 1.2m (4ft) least and avoid any steps, sitting bar and
light under the installation area.)
Quick Start Guide
Step 3 -WYBOT App setting& mode selection
(If you do not need presetting, you may skip this step)
Step 2 -Charge the device
WYBOT S2Pro
7 8
9
Please download WYBOT
from the Google Play or
App Store.
Register your account as
per App direction.
Customize your cleaning
mode via App when the ro-
bot is in the pool.
①
②
Select a mode via the toggle.
Either way is workable.
or
MODE
MODE
1
2
3
Please paste the hook on
the area 20mm (0.8in)
above the waterline,
ensuring that the area is
flat, dry, and free of dirt.
Take out three included
tapes and put them onto
the back of the hook.
Hook the docking station
after the hook being cured
for at least 48 hours.
Connect and stretch out
the charging line.
Hook Back Side
Plug the adaptor into a
power supply.
48 hours later
4
5
6
Turn on the device and put
it into the pool vertically.
After calibration, press
button to call the cleaner
back to the docking sta-
tion.
Start to fully charge itself
automatically
Fully Charged！
MODE
MODE
Enable your mobile phone
Bluetooth.
Open your app and search
WYBOT S2 Pro When it is
charging (green light) on the
docking station.
3.5m (11.5ft)
The device will keep static
in the pool for 20 seconds
to calibrate itself.
MODE
MODE
No charging devices on shore
using docking station.
During curing, please
ensure that the hook
bears no weight.
20mm(0.8in)

Summary

Install the Docking Station

Hook Installation and Curing

Install hook with tapes, ensuring flat, dry surface, 20mm above waterline. Cure for 48 hours without weight.

Connect Charging Line

Connect and stretch charging line, plug adaptor into power supply.

Charge the Device

Device Placement and Calibration

Place device vertically in pool, let it calibrate for 20 seconds.

Automatic Charging

Device will automatically move to docking station to fully charge.

App Settings and Mode Selection

Download and Setup App

Download WYBOT app, register account, and enable Bluetooth.

Connect and Control

Open app, search for WYBOT S2 Pro, and select cleaning modes.

Start Cleaning

Initiate Cleaning Cycle

Start pool cleaning via the button on the device or the app.

Cleaning Process

Cleaner operates on walls, floor, and waterline; controllable via app.

Removal from Pool and Filter Cleaning

Automatic Return and Removal

Device returns to docking station when cleaning is complete or battery is low.

Filter Maintenance

Clean the filter after each use for optimal pool cleaning performance.

WYBOT S2Pro Specifications

General

Programmable	Yes
Type	Robotic
Pool Type	Above Ground & In-Ground
Filter Type	Fine Filter
Remote Control	Yes
Climbing Ability	Yes