Wyrestorm SW-515-RX

To Next Page

To Previous Page

Setup and Conguration

The SW-515-RX is congured using RS-232 and/or Telnet commands for IP address, Output Resolution, and EDID. Follow these steps to properly congure the

extender based on the system requirement.

Note: The steps and information provided in this QSG are for basic operation of the extender out of the box. Refer to the SW-515-RX API for full conguration

settings.

1. Assign a Static IP Address to ensure proper communication on an IP Network. See Conguring a Static IP Address

2. Set EDIDs to be used at each input of the device. See Conguring Input EDIDs

Communication Settings

The commands listed below can be sent by connecting to either the TX or

RX for RS-232 and the RX only for Ethernet. Each device must be connected

together via HDBaseT in to order to send a command from one device to the

other. The only exception is Conguring a Static IP Address which requires

connection to the RX.

The SW-515-RX contains a web UI that can be accessed by connecting to a

network and entering the IP address. We recommend that the IP address is

changed from default before accessing the web UI for the rst time.

RS-232 and IP Settings

Baud rate: 115200

Data Bits: 8bits

Parity: None

Stop Bits: 1bit

Flow Control: None

Default IP Address 192.168.11.43

Default IP Port 23

Conguring a Static IP Address

By default, the switcher is set to a static IP of 192.168.11.043. We recommend changing this as it shared with other WyreStorm products and may cause

improper communication if left unchanged. Connect to the RX via RS-232 and send the following command to set the IP address.

Conguring Input EDIDs

By default, all inputs are set to an EDID or 1920x1080@60Hz 2CH. However, this can be congured to suit the installation.

SW-515-RX Quickstart Guide | 191212

UK: +44 (0) 1793 230 343 | ROW: 844.280.WYRE (9973)

support@wyrestorm.com

3 of 4

SET IPADDR STATIC ip4addr [IP Address] netmask [Netmask]<CR><LF>

Example: SET IPADDR STATIC ip4addr 192.168.11.243 netmask 255.255.255.0 <CR><LF>

Response: IPADDR STATIC ip4addr 192.168.11.243 netmask 255.255.255.0 <CR><LF>

Note: This command can only be sent to the receivers (RX) RS-232 port.

Set Input EDID

SET EDID [Input] [Resolution] [Device]<CR><LF>

Example: SET EDID in1 1 tx<CR><LF>

Response: EDID SET in1 1 tx<CR><LF>

Query Input EDID

GET EDID [Input] [Device]<CR><LF>

Example: GET EDID in1 tx<CR><LF>

Response: EDID GET in1 1 tx<CR><LF>

Resolution={Below tables based on connection}

VGA EDID HDMI/USB-C EDIDs

1024x768@60Hz 2CH 1024x768@60Hz 2CH

1280x768@60Hz 1280x720@60Hz

1360x768@60Hz 1360x768@60Hz

1440x900@60Hz 1440x900@60Hz

1600x900@60Hz 1600x900@60Hz

1680x1050@60Hz 1680x1050@60Hz

1920x1080@60Hz 1920x1080@60Hz

1920x1200@60Hz 3840x2160@30Hz

Wyrestorm SW-515-RX - Page 3

Related product manuals