X-lite X-1005 - Page 25

25
X-1005
SETTING UP THE N-COM - HELMET COMMUNICATION SYSTEMS
(Available depending on the product version)
Your helmet is factory-preset to be equipped with the N-Com communication system.
During the communication system installation (see the specic instructions contained
in the N-Com kit), it will be necessary to remove from the helmet the foam material llers
located in the polystyrene cheek pads next to the N-Com earphones seats.
The above-mentioned llers should only be removed if the helmet is used with a
compatible N-Com system installed.
INSTRUCTIONS FOR USE