USB SATA HDD/SSD External Enclosure
Page | 4
1.2 Features
Support most 2.5” 7mm/9.5mm SATA HDD/SSD
USB 2.0 data transfer rate up to 480Mbps (Model: XM-EN2279)
USB 3.0 data transfer rate up to 5Gbps (Model: XM-EN2279U3)
Tool Free case design for easy installation
USB Bus-Powered
PC and MAC compatible
Hot Swappable, Plug and Play
LED indicator
1.3 System Requirement
Internal 2.5” SATA compatible storage device
USB enabled computer system with available USB port
Microsoft® Windows® 2000/XP/Vista/7/8.x/10 (32/64-bit); MAC 9.x or above
Chapter 2 Installation Guide
WARNING: Hard Disk requires careful handling, especially when being transported. If you are not
careful with your hard disk, lost data may result. Always handle your hard disk or
storage device with caution.
2.1 Hardware Installation
To Install the Enclosure, please follow these steps listed below:
1. Lightly press on the top panel of Enclosure as shown on Figure 1.
Figure 1
2. Lift up the top panel as shown on Figure 2.
To Next Page
Loading...
General