Xcel-Arc VIPER Plasma CUT30 User Manual

14
● Piercing
Hold the torch at an angle to the work piece,
pull the trigger to start the arc and slowly
rotate it to an upright position.
When sparks are exiting from the bottom of
the work piece, the arc has pierced through
the material.
When the pierce is complete, proceed with
cutting.
● Safety Trigger Operation
The Suregrip SC40 torch supplied with the Viper Cut 30 machine has a new design of safety trigger.
Just pull back on the trigger whilst increasing your grip and you will feel the trigger move to the on position.
When you release the pressure it will return to the o󰀨 position.
o󰀨
on
o󰀨
PLASMA CUT30
Operating Procedure & Techniques
for PLASMA Cutting

Xcel-Arc VIPER Plasma CUT30 Specifications

General

Brand	Xcel-Arc
Model	VIPER Plasma CUT30
Category	Welding System
Language	English