Installation ways
Installation ways
1.Ensure that the water pressure range of the inlet is between 0.05-0.75Mpa.
2.Be sure to use the original accessories and consumables.
3.Please do not switch on the power until the installation is completed to avoid failure
Precaution before installation
Method of mounting base
Press the buckle
1.Draw the fixing plate from the machine
2.Install the accessories as shown in the diagram
1.Remove the existing toilet seat/lid.Put the expansion screw rubber intothe toilet mounting hole.
2.Put the fixing plate, adjustment pad and adiustment sheet metaorderly on the toilet.
3.After fixing tighten the screws
PAGE 07PAGE 06
Installation method
Pressing the buckle while aligning the bidet
to both sides of the fixing plate,
and push along the arrow direction.
The lock catch makes a "click" sound,
indicating that the installation is complete
Screw
Adjustment pad
Adjustment sheet
Fixing plate
Rubber expansion screw
Disassembly method
Unplug the power cord and DMT tube first,
pressing the buckle while pull out the bidet
from the fixing plate.
To Next Page
Loading...