Trial operation
1. Please check each function according to the manual
2.Switch on the power and put a wet towel on sensor
areaAfter one minutes, the water will be heated as set
temperatureand the warm air will work when you press the
drying key.
3.When there is no power supply , no function can work.
Function confirmation
Temperature safety reset protector integrated.
Toilet will shutdown if temp. is out of specs.
Lowest water pressure is 100 kPa (14.5 psi),
highest water pressure is 500 kPa (72.5psi)
Technical parameter
PAGE 15PAGE 14
product.
To avoid freezing of DMT pipes/three-way valves due to low winter temperatures,
please take the following antifreeze measures:
--Raise indoor temperature.
--Close the water supply valve.
--Drain the water from the DMT pipe.
To Previous Page
Loading...