Xerox 8264E User Maintenance and Cleaning Guide 10
2. Cleaning method
Follow the procedure below to clean around the print head.
CAUTION:
Use the gloves included in the cleaning kit to prevent ink and cleaning solvent
from getting on your hands. Do not touch the rubber cap without gloves. Oil from
your hands may prevent the cap from sealing properly.
Follow the procedure below to clean around the print head.
Notes:
Before starting to clean around the print head, read and understand this
procedure, then clean promptly and accurately.
When cleaning around the print head, the print head cap must be removed and
cleaning must be complete before the head dries. The recommended time for
cleaning is about fifteen minutes.
If cleaning exceeds fifteen minutes, discontinue it by following Steps 7 and 8.
Perform a head cleaning, and then start cleaning around the print head again.
Cleaning the Head
Use the foam swab to clean around the print head.
For information on the foam swab, refer to Options/Supply List.
1. If the printer is turned ON, make sure of the following.
Printing or other operations are not in progress.
"Ready to Print" is displayed in the control panel.
2. Display the CR Maintenance menu in the control panel.
a. Press the [Menu] key. "Menu 1: Setup>" displays in the control panel.
b. Press the [>] key. "Set1: MediaType" displays in the control panel.
To Next Page
Loading...
Need help?
General
