10/2006
4-4
Phaser 8510/8560MFP Multifunction Product
Disassembly Overview, REP 1.0.1
Initial Issue
Repairs and Adjustments
Reco
Table 1 list s basic, recom mended, and opt ional t ools used to ser vice t his and ot her similar
products.
REP 1.0.1 Front Door / Tray 1 Assembly
Parts List on PL 1.0
Removal
1. Open the Front Door and release the 2 Stopper Straps.
Figure 1 Releasing the Front Door Stopper Straps
2. Open the plug cover and disconnect P/J650 from the right side of the Front Door (Tray1/
MPT).
3. Fr
ee the plug wiring from cable retainers.
4. Carefully remove the Front Door (Tray 1/MPT) assem bly b y releasing t he lef t hinge pin
from the frame and sliding the door to the right to remove it.
Table 1 Recommended Service Tools
Description Detail
Torx Drivers Bits T5, T8, T10, T15, T20
Phillips Drivers Phillips # 2 and # 1 5.0 x 75 mm, 3.0 x 75 mm, 6.0 x 100 mm
Flathead Drivers 5.0 x 75 mm, 3.0 x 75 mm
Torque Screw Driver Required for this system P/N 003082700
Hex Bit 2.5mm Hex Bit, T-20 P/N 003086600
Driver Extension
Small Channel lock Pliers
Needle Nose Pliers
Wire Cutters
Flashlight
Assorted Nut Drivers
Lint-Free Cloths
Cleaners Multipurpose surface cleaner and Alcohol
ESD Strap
Nut Driver 5.5mm (magnetic) P/N 600T2123
Network Cross-over cable Tech
Scanner Calibration page P/N 109K01910
Toner Vac Toner and general cleaning
Multimeter Volts, Ohms, Current
Lubricant/Grease Reolube P/N 006799700
To Next Page
Loading...
