Xerox WORKCENTER 5222 - Page 21

dc08cc0440
Customer Support Page 21
Feature Implementation Values
Stapling
(w/ finisher)
<</Staple int1
/StapleDetails << /Type 7
/Location int2 >>
>>
setpagedevice
Where int1 is one of the following:
0* = Do not staple
3 = Staple at the end of each set
Where int2 is one of the following:
0* = top-left-single
1 = bottom-left-single
2 = top-right-single
3 = bottom-right-single
4 = top-double
5 = bottom-double
6 = left-double
7 = right-double
Punch
(w/ fnisher)
<</Punch int1
/PunchDetails << /Type 5
/Position int2
/Numholes int3 >>
>>
setpagedevice
Where int1 is one of the following:
0* = Do not punch
3 = Do punch by set unit.
Where int2 is one of the following:
0 = topside
1 = bottom side
2 = left side
3 = right side
Where int3 is one of the following:
2 = 2 holes
3 = 3 holes
4 = 4 holes
Booklet
(w/ finisher
and booklet
module)
<</Booklet value1
/BookletDetails << /Type 3
/StapleType int
/PrintInside value2
/PageSet value3>>
>>
setpagedevice
Where value1 is one of the following:
true = Do Booklet.
false* = Do not Booklet.
Where int is one of the following:
0* = Do not file on inside.
1 = File on inside.
Where value2 is one of the following:
true* = Print on inside.
false = Print on outside.
This feature is effective only in conjunction
with that StapleType is 0.
Where value3 is one of the following:
true = Integrate several page and folds.
false = Fold every page.
This feature is effective only in conjunction
with that StapleType is 0.