Xerox WORKCENTER 5222 - Page 6

Feature Implementation Values
<ESC>&l int H Where int is one of the following:
0: Feed paper from default tray
4: Tray1
1: Tray2
5: Tray3
8: Tray4
7 or 20 = Auto
2 or 3 or 6 = Tray5 (Bypass)
21: Tray6
Output
Location
@PJL SET OUTBIN = value Where value is one of the following:
UPPER: Center output tray (w/o finisher)
MAINTRAY: Center output tray (w/o
finisher)
CENTERTRAY: Center output tray (w/o
finisher)
MAINTRAY2: Center output tray (w/ B-
Finisher)
LOWER: Side Tray (facing up) (w/ side tray)
SIDETRAY: Side Tray (facing up) (w/ side
tray)
OUTBIN101: Finisher tray (w/ finisher)
<ESC>&l int G Where int is one of the following:
0: Automatic Selection
1: Center output tray (w/o finisher)
2: Side Tray (facing up) (w/ side tray)
4: Center output tray (w finisher)
6: Finisher tray (w/ finisher)
Stapling @PJL SET STAPLE = value Where value is one of the following:
TOPDUAL
TOPLEFT
TOPRIGHT
BOTTOMDUAL
BOTTOMLEFT
BOTTOMRIGHT
LEFTDUAL
RIGHTDUAL
SADDLE
NONE
Punch
@PJL SET PUNCH =
value1
@PJL SET JOBATTR =
”@PNHN = value2”
Where value1 is one of the following:
TOP
RIGHT
LEFT
BOTTOM
NONE
Where value2 is one of the following:
TWO: 2 holes
THREE: 3 holes
FOUR: 4 holes
dc08cc0440
Customer Support Page 6