5. Usage
5.1 SIM card installation
Make sure that there is no call transfer and call display is on, and PIN code off. The SMS
message must in Text format, can’t be identified for PDU format.
Steps:
1. Open the rear cover, and pick out the battery.
2. Push the foil along and turn it left.
3. Put the SIM card into the holder, and turn the foil right and fasten it in place.
5.2 Battery and Charger
Do charge the battery to capacity in 8 -12 hours for first use.
Please use the battery and charger provided by the manufacturer.
This unit adopts built-in Li-ion battery, and full battery will support around 48 hours use on end.
After first use, the battery can be charged fully in 3-5hours.
Cautions:
a: For it’s Li-ion battery, which contains harmful chemicals and may burst, please don’t
bump, puncture it violently and keep it off fire.
b: Please charge the battery in time to keep it working normally.
5.3 Start up
• Put the SIM card and battery in place.
• Turn on the unit outdoors by pressing the “on/off” button until the indicator is on.
• For first use, please initialize the unit and restore it to default setting.
(Please refer to 5.4 for instruction.)
• In 10 or 40 seconds, the unit will begin to work and acquire the GSM signals as well as
the GPS signals. The indicator will keep flashing every 4 seconds when the unit
has received the signals, otherwise it will keep on.
custom_efficiency@yahoo.com www.customsales.webs.com Phone: +316-5326-7060
To Next Page
Loading...
