1. When not in use, store the pod in the package box. The recommended
storage environment is a relative humidity less than 40% at a temperature
of 20±5° C. If the lenses fog up. The water vapor will usually dissipate after
turning on the device for a while.
2. Do not expose the thermal camera lens to a strong energy source such as
sun, lava or laser beam. The temperature of the observation target should
not exceed 600℃ , otherwise it will cause permanent damage.
3. Do not place the product under direct sunlight, in areas with poor
ventilation, or near a heat source such as a heater.
4. Do not frequently power on/o the product. After it is turned o, wait at
least 30 seconds before turning back on, otherwise the product life will be
aected.
5. Make sure the pod port and pod surface are free from any liquid before
installation.
6. Make sure the pod is securely installed onto the aircraft.
7. Do not plug or unplug the microSD card during use.
8. Do not touch the surface of the camera lenses and keep it away from hard
objects. As doing so may lead to blurred images and aect the imaging
quality.
9. Clean the surface of the camera lenses with a soft, dry, clean cloth. Do not
use alkaline detergents.
10. When not receiving valid carrier INS data, the yaw shaft of the pod will drift
about 15 degrees per hour because of the earth rotation. To make sure
the pod attitude corrects, it is necessary to transmit valid carrier INS data,
usually the GNSS should be positioning.
11. When its damping platform tilted over 45° , the pod will trigger protection
mode and return to its neutral position. (except in FPV mode)
Caution
To Next Page
Loading...