2. Medium Wave Step——[ 9/10 kHz ] button
The tuning step for medium wave (MW) can be set for 9 kHz or 10 kHz. To change the setting,
turn the radio off and long-press the [9/10 kHz] button (number 0) ,and then press the button
again to switch the two options, the current setting is displayed.
3. Long wave——[ LW / MW ] Button
The LW band is not enabled by default. To enable it, turn the radio off and long press the
[LW/MW] button. The radio will display the current status of the setting, “LW ON” or “LW OFF”.
To change the setting, press the [LW/MW] button.
When LW is enabled , pressing the [LW/ MW ] with the radio on selects either the LW or MW band.
When it is disabled, the LW option is not available.
4. Temperature——[ DISPLAY ] Button and [ number 3 ]
The temperature scale for display, Fahrenheit or Centigrade, may be selected. With the radio off,
repeatedly press the [DISPLAY] button until the temperature is displayed, then long-press the
[number 3] to change the setting. Repeatedly press the button to toggle between °F and °C.
5. Setting the time——[ TIME SET ] Button
The radio clock supports 24-hour time display only.
To set the clock, turn the radio off and long press [TIME SET] button . The radio will display “TIME”
Key in the 4-digit time to set. Note that time setting mode automatically exits after about 5
seconds with no key pressed.
The radio has the option to automatically set the time from an FM broadcast station that
provides it (refer to the RDS topic for more on this). To enable automatic setting, press the [TIME
SET] button with the radio off. Use the [UP arrow] key to switch between Auto and Manual
modes.
(Note: Many FM stations do not broadcast time, and those that do may not be accurate. You
must manually tune the station with time information for the time to be set from RDS.)
6. Setting the alarm——[ ALARM ] Button
With the radio turned off, long press the [ALARM] button. Use the 0-9 keys to directly enter the
alarm
time.
Quickly press
the [ALARM] button, then the "ALARM" icon will flash. Press the [Up Arrow] or
[Down Arrow] button to select the way the alarm rings:
①Radio Broadcast Alarm ②
Buzzer Alarm ③ Alarm off.
· Buzzer Alarm：By default, the radio will sound
a buzzer when the alarm time is reached.
· Radio Broadcast Alarm ：A speaker
icon will appear on the screen, indicating that the alarm will
play
the last radio station tuned when the alarm time is reached.
When the
alarm goes off, press the [Power] button to turn off the alarm or press any other
button to sleep for another 10
minutes.
7. Setting the sleep timer——[ POWER ] Button
To use the Sleep Timer, quick press the [POWER] button. The Sleep Timer will automatically shut
off the radio after the set amount of time expires. The display will cycle through minutes 120, 90,
60, 45, 30, 15. Setting the value to “ON” turns off the Sleep Timer.
To Next Page
Loading...
