RED Declaration of Conformity
We, Xiaomi Communications Co., Ltd.,
Hereby, Xiaomi Communications Co., Ltd., declares that this GSM/GPRS/ EDGE/UMTS/LTE Digital Mobile Phone with Bluetooth and WiFi M1903F2G is in compliance
with the essential requirements and other relevant provisions of the RE Directive 2014/53/EU. The full text of the EU declaration of conformity could be consulted at
www.mi.com/en/certification
Body-worn SAR testing has been carried out at a separation distance of 5 mm .To meet RF exposure guidelines during body-worn operation, the device should be
positioned at least this distance away from the body.
If you are not using an approved accessory, ensure that whatever products used is free of any metal and that it positions the phone with the indicated distance away from
the body.
Receiver Category 2
Legal Information
This device may be operated in all member states of the EU. Observe national and local regulations where the device is used. This device is restricted to indoor use only
when operating in 5150 to 5350Mhz frequency range in following countries :
AT BE BG HR CY CZ DK
EE FI FR DE EL HU IE
IT LV LT LU MT NL PL
PT RO SK SI ES SE UK
Ensure the power adapter used meets the requirements of Clause 2.5 in IEC60950-1/EN60950-1 and has been tested and approved according to national or local
standards.
Frequency Bands and Power
This mobile phone offers the following frequency bands in EU areas only and maximum radio-frequency power :
GSM 900: 35 dBm
GSM 1800: 32 dBm
UMTS band 1/8: 25 dBm
LTE band 1/3/7/8/20/28/38/40: 25.7 dBm Bluetooth: 20 dBm
Wi-Fi 2.4 GHz band: 20 dBm
Wi-Fi 5 GHz: 5150~5350MHz: 20dBm, 5470~5725MHz: 20dBm, 5725~5825MHz: 14dBm
NFC: 13.56Mhz < -5.75 dBuA/m at 10m
FCC Regulations
This mobile phone complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and
(2)this device must accept any interference received, including interference that may cause undesired operation.
This mobile phone has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interference will not occur in a particular installation in If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Information (SAR)
This device meets the government’s requirements for exposure to radio waves. This device is designed and manufactured not to exceed the emission limits for exposure
to radio frequency (RF) energy. The exposure standard for wireless devices employs a unit of measurement known as the Specific Absorption Rate, or SAR.
The SAR limit set by the FCC is 1.6W/Kg. For body-worn operation, this device has been tested and meets the FCC RF exposure guidelines for use with an accessory
that contains no metal and positions the device a minimum of 1.0 cm from the body. Use of other accessories may not ensure compliance with FCC RF exposure
guidelines. If you do not use a body-worn accessory and are not holding the device at the ear, position the handset a minimum of 1.0 cm from your body when the device
is switched on.
FCC Note
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
E-label
This device has an electronic label for certification information. To access it, please select Setings> About Phone >Certification or select Setings, then type
To Next Page
Loading...
