2. Turn the post-filter as illustrated to remove it.
Post-filter
3. Rinse the filter, pre-filter, and post-filter under running tap water until clean, then set them
aside to fully dry for at least 24 hours.
Notes:
Never soak the filter, pre-filter, and post-filter.
When cleaning the post-filter, rinse it repeatedly and its edge lightly to remove any dust
and debris until it is clean.
Do not clean the pre-filter and post-filter with your hands, a brush, or a sharp object
to prevent damage.
If the suction power is still significantly reduced after the pre-filter and post-filter are
cleaned, you can try to purchase and replace them with genuine ones.
Cleaning the electric brush bar
1. Place the brush bar upside down and press the roller brush release button to unlock the roller
brush and remove it
Roller Brush Lock
Roller Brush
Release Button
2. Use a dry cloth or paper towel to wipe dust and debris from the suction opening
and the transparent cover.
Note: Do not clean the electric brush bar with water as it has a built-in motor.
3. Reinstall the roller brush, and press the lock it into place.
To Next Page
Loading...
Need help?
General
