Care & Maintenance
CAUTIONS:
Before care and maintenance, unplug the power supply and make sure the vacuum
cleaner is turned of.
Always use geuine parts to ensure normal operation and to kepp your warranty valid.
If the filter, pre-filter, post-filter, extension rod, or 2-in-1 brush nozzle is blocked, the vacuum
clenaner will stop working. Before using the vacuum cleaner again, turn it off and clean the
blocked part.
If the brush bar gets blocked, it will stop working but the vacuum cleaner itself will not. Before
using the vacuum cleaner again, turn it off and clean the brush bar.
Before cleaning, remove the brush head from the vacuum cleaner to prvenet accidentally
turning on the vacuum cleaner, which can cause injury.
If the vacuum cleaner will not be used for an extended period, fully charge it and disconnect
it from the power then store it in a cool, low-humidity environment away from direct sunlight.
To avoid over-discharging the battery, recharge the vacuum cleaner at least once every three
months.
Cleaning the Vacuum Cleaner
Wipe the vacuum cleaner with a soft, dry cloth.
Cleaning the dust compartment
Before cleaning the dust compartment, disconnect the power sy and remove the extension rod.
The vacuum's cleaning ability will be reduced if the dust compartment is filled to the "MAX" mark.
To regain performance, empty the dust compartment.
Empty the dust compartment: Hold the dust compartment over a trash bin, then press the dust
release button to empty out the contents.
Cleaning the filter assembly
1. Press the dust release button to open the dust compartment, turn the filter as illustrated to
remove it, then remove the pre-filter from the filter.
Pre-filter
Filter
To Next Page
Loading...
Need help?
General
