XIRO Xplorer - Charging Smart Flight Battery and Remote Control

Charge Smart Flight Battery and Remote Control
Prior to ying your new Xplorer, it is strongly
recommended that you completely familiarize yourself
with the drone as well as the complete contents of this
manual. This will ensure many safe and pleasant ights
and experiences.
• Firstly, we recommend watching our tutorial videos to
show you the correct and safe way to use your Xplorer.
Please visit www.xirodrone.com/video/xplorer.
CHARGING THE BATTERIES
• You will note that there are two batteries included
with the Xiro Xplorer; one in the transmitter and a
ight battery for the model. Both batteries should be
charged using the supplied battery charger. DO NOT
use any other chargers to charge the ight battery.
Charger
• Remove the charger and the charger accessories from
the box labeled “Power Pack”.
• After you’ve attached the power cord to the AC
adapter, plug the other end of the AC adapter into the
charger base. Plug the power cord into the AC power
source. The LED on the AC adapter should be solid
green. Insert the appropriated end of the USB cord into
the USB port on the rear of the charge base.
Charging the Transmitter Battery
• When fully charged, the transmitter battery should
provide approximately two hours of operational usage.
It is strongly suggested that the battery is completely
charged prior to each day’s ights. To do so:
> Remove the transmitter from the box labeled
“Remote Control”.
> Plug the remaining end of the USB cord (micro) into
the USB receptacle on the bottom of the transmitter,
as shown. The battery indication LED will glow red
while the battery is charging, or when the battery
status is low. Once the battery has been fully
charged, this LED will change to green, indicating
that the transmitter is ready to use. Please make sure
that the transmitter’s power switch is turned to the
OFF position when charging.
• For more information on the status of the transmitter
battery, please reference the “Battery Indicator
Information” section located elsewhere in this manual.
Charging the Flight Battery
• The ight battery (also might be referred to
interchangeably as a Smart Battery within this manual)
for the Xiro Xplorer is a Lithium Polymer (commonly
referred to as a LiPo) battery. Used properly and with
caution, the battery is very safe and will provide many,
many hours of pleasant and trouble-free operation.
That said, this battery should be treated very
cautiously to prevent any difculties. Please refer to the
section on the “Smart Battery Safety Guidelines” for
additional information on how to do so.
• There are four LEDs on the battery. When in the charge
base, the LEDs indicate the current charge status of
the battery. If all four are lit, the battery is charged
completely (100%). If only one is lit, the battery is at (or
below) 25% of the charge capacity.
50％－75%
25%－50%
0－25%
75%－100%
Battery Status: Normal
Battery Status: Low
Charging (Remote Control OFF)
Charging (Remote Control ON)
Remote Control OFF
Remote Control ON
Battery indicator
in Remote Control
Charging
Use the Plug Adapter
if necessary
The Remote Control can be charged by
PC or USB charger
Battery Status: Full
Indicator blinking
Charging
Battery Level
indicators
Battery Level
Check button
All indicators OFF
Battery Status: Full
• To determine the battery charge status outside of the charge
base, simply press the green button located next to the LED
indicators. Again, if all four LEDs are lit, the battery is 100%
charged and ready for ight.
• For more information on the status of the ight battery, please
reference the “Battery Indicator Information” section located
elsewhere in this manual.
3