Xirrus XR Series - Page 6

XR-2425H Q uic k Insta lla tio n Guid e
- 4 -

Hand tighten the Band-
It strap through the pole mounting
bracket, thread it through the strap buckle and then bend
the strap back.

Using the Band-It tool, place the tool onto the strap.

Rotate the Band-It tool so that it can pull the excess strap
through the buckle and turn the crank until the strap is
very tight.

Once the strap is satisfactorily tight, rotate the Band-
It tool
back so that the strap cannot slide back through the
buckle.

Using the built in cutting tool on the Band-It tool, cut the
excess strap.