To Next Page

To Previous Page

b) Route the antenna wire under the rubber molding around the front

windshield to the nearest corner. Then route the cable out of the windshield

molding and into the rubber weather stripping around the door opening. Lift the

weather stripping from the open-

ing and tuck the cable inside it,

then replace the weather strip-

ping. Run the cable inside of the

weather stripping to the bottom

of the door opening.

c) Recommended: Hide the antenna

wire inside the cabin. Pull the

cable out of the weather strip-

ping at the bottom of the door

opening and route it under the

carpet toward the 12V power

socket. Coil any excess cable in a

hidden location, such as under the

carpet, keeping it away from any

vehicle pedals or controls. Secure

the excess cable with wire ties.

TIP! Always be careful to include enough slack in your routing to accommodate open doors

or trunk lids. Use electrical tape to secure the cable in areas so that hinges do not pinch the

cable with the door.

Place Antenna

Closer to A-Pillar

if Cable Doesn’t Reach

Center of Roof

12V

Power Socket

Location

XM SkyDock User Manual

Questions and Answers: