Xpand X101 User Manual



XPAND3DCinemaGlasses
Instructionsfor3Dcinemaglasses
TheactiveglassesX101workinautomaticmode–thereisnopowerswitchtoturntheglasses"ON"
or"OFF".Uponreceivingtheglasses,theyareintheoff‐mode,meaningthattheglassesperiodically 
check forthe valid IRsignal. Inthe off‐modethelenses  appear green.Upon
receivingthe IR signal,
theglassesstartawarm‐upsequence.
Warm‐upsequence‐Duringthe warm‐upperiodthelensesremain opaqueforthe entirewarm‐up
periodwhichlasts fortwoseconds.Attheendofawarm‐upperiodtheglassesgointonormalrun‐
mode.In
thismode,thelensesopenandcloseinsyncwiththeprojectortodeliverthe3Dexperience
totheviewer.
Clearmode‐Wheninrun‐mode,after theglassesloosea validsynchronization signal,theygotoa
clearmode (both lensesclear). Inthe clearmode, both lensesremain open,
so thattheviewer can
seenormallythroughtheglasses.Thelensesremainopenuntiltheglassesareabletoreceiveasync
signal.Iftheydon'treceivethesignalinfiveminutestheygotoanoff‐mode.
Batterylife‐Theglassescheckforalowbatteryconditionjust
beforegoingtothe"off‐mode".Ifthe
batterylifeisinsufficientthelenseswillbeginblinkingslowly(thelensesareclosedandbrieflyflash
open simultaneously once every two seconds) to indicate a low battery condition and prevent the
glassesfromgoingtorun‐mode.Thecontrolcircuitisdesigned
sothatalowbatteryconditiondoes
notappearduringtherun‐modewhenwatchingamovie.
Replacingthebattery‐Accesstothebatteryisprovidedthroughanopeningontheinteriorsideof
the framethat is sealedoffby a cover.In the caseof dead battery,the
sealis opened using akey,

Xpand X101 Specifications

General

Brand	Xpand
Model	X101
Category	3D Glasses
Language	English

Summary

XPAND 3D Cinema Glasses

Glasses Operation Modes

Details automatic mode, warm-up, clear mode, and off-mode based on IR signal reception.

Battery Life and Replacement

Covers low battery indications, usage duration, and battery replacement access.

Glasses Testing Procedures

Explains how to test glasses functionality using the AT100 Active Glasses Tester.

Handling and Care Instructions

Provides guidelines for storage, handling, and cleaning of the 3D glasses.

XPAND 3D Cinema IR Emitter System

AE210-Emitter, Long-Range, Narrow Angle

Powerful emitter for small/medium theaters, 10° angle, includes laser pointer for alignment.

AE225-Emitter, Long-Range, Wide Angle

Powerful emitter for small/medium theaters, 25° angle, includes laser pointer for alignment.

AE110-Emitter, Mid-Range, Narrow Angle

Medium range emitter for up to 100 seats, 10° angle, 4W power consumption.

AE125-Emitter, Mid-Range, Wide Angle

Medium range emitter for wider coverage, 25° angle, 4W power consumption.

AD1000- Sync Distribution Module

Receives sync signal, converts it, powers emitters, and monitors performance.

System Verification and Operation

Details system installation, test generator, indicator lights, and operational checks.