XPower B-2 - How to Operate the Vacuum Function; Air Bleed Hole for Vacuum Mode

- 6 -
• Important: Always keep air bleed hole on the hose open when vacuuming in order to
prevent overheang of the motor. This hole is usually closed when drying.
Fig. D
1. Unscrew the hose from the front connector.
2. Remove outer inlet filter and crossed cover of the rear cover (Fig. B).
3. Connect the hose to the rear cover connector (Fig. C) and aach square nozzle.
4. ALWAYS keep air bleed intake hole on the hose open when vacuuming in order to prevent
overheang motor (Fig. D).
5. IMPORTANT! Cleaning Dryer Dust Case, Rear Cover and Filters is required BEFORE converng
unit back to dryer. See maintenance secon for complete cleaning instrucons. Serious damage
to the motor can occur in drying mode if clean filters and dust case are not in place.
VACUUM OPERATION
Fig. B
Fig. C