30
RIDE HEIGHT ADJUSTMENT
DROOP ADJUSTMENT
FOAM TIRE TIPS
960140
N M4
DETAIL
8. FINAL ASSEMBLY
WARNING!
Follow the adhesive manufacturer's instructions
for proper use and safety. Wear proper eye and
hand protection.
CA
Make sure the wheel nuts are very tight, so the
wheels do not loosen during racing.
FIBRE TAPE
(HUDY #107870)
(NOT INCLUDED)
5-CELL OR 6-CELL INLINE BATTERY PACK OR
LIPO BATTERY PACK
(NOT INCLUDED)
US Foam-Spec Notice:
Some foam wheels may be slightly wider and may touch the front steering blocks. To correct this, we recommend
grinding the inside edge of the wheel using a tire truer and a file. Make sure that both front tires/wheels are set to
the same width, and that there are no rough edges.
WHEELS & TIRES & INSERTS
(NOT INCLUDED)
Also, make sure that the front wheels and tires do not touch the steering blocks when the steering is turned, and
that the wheels and tires do not touch the shocks.
4x
or the optional battery holders:
#306163-K XRAY Graphite Battery
Holder (for 6-cell chassis) - Black
The XRAY Graphite Battery Holder
can be used for LiPo as well.
However, depending on the height
of the LiPo batteries additional shims
may have to be mounted below
the stands.
We recommend using #107870
HUDY Fibre Reinforced Tape
BATTERY ASSEMBLY CONFIGURATION
5-CELL REAR POSITION ALTERNATIVE 5-CELL FRONT POSITION ALTERNATIVE
To Next Page
Loading...
Need help?
General
