Xray T3 - Aluminum Ball Differential Assembly; Composite Front Solid Axle Assembly

7
ALU BALL DIFF. & FRONT SOLID AXLE
COMPOSITE FRONT SOLID AXLE (EU RUBBER-SPEC ONLY)
FRONT & REAR AXLES
902310
SH M3x10
941015
BB 10x15x4
OIL
OIL
DO NOT TIGHTEN THE DIFF COMPLETELY
THE DIFF MUST BE BROKEN IN PROPERLY !
IMPORTANT: When you build the differential, do not tighten it fully initially; the differential needs to be broken in properly. When you build the diff tighten it very gently.
When you put the diff in the car and complete the assembly, run the car for a few minutes, tighten the diff a little bit, and then recheck the diff. Repeat this process
several times until you have the diff tightened to the point you want it. Final adjustments should ALWAYS be made with the diff in the car and on the track.
OIL
BEARING OIL
(HUDY #106230)
BEARING OIL
(HUDY #106230)
BEARING OIL
(HUDY #106230)
FRONT & REAR AXLES
#305003 ALU DIFF 34T + 38T PULLEY
#305104
XRAY ALU MULTI-DIFF™
#305188 COMPOSITE SOLID AXLE 38T PULLEY
CUTAWAY VIEW
EU RUBBER-SPEC
38T Pulley