DIRTCARPET
902306
SH M3x6
NOTE
ORIENTATION
Pinion & Set screw
(NOT INCLUDED)
GEAR MESH
Adjust the motor so the pinion meshes
with the spur gear properly. Make sure
the gear mesh is not too tight.
There should be a small amount of
play between the teeth of the pinion
gear and the spur gear.
Motor
(NOT INCLUDED)
GEARING CHART
SPUR
GEAR
PINION
MIN.
PINION
MAX.
69T
27T 43T
72T 24T 40T
75T 21T 37T
78T 18T 34T
81T 15T 31T
GEAR
RATIO
Final Drive Ratio
(Spur) (Pinion) (IGR)
78
:
X
x
2.65
= FDR
PINIONS (48P)
#294017 17T
#305918 18T
#305919 19T
#294020 20T
#294021 21T
#294022 22T
#294023 23T
#305924 24T
#305925 25T
#365726 26T
#365727 27T
#365728 28T
#365729 29T
#365730 30T
#365731 31T
#365732 32T
#365733 33T
#365734 34T
#365735 35T
#365736 36T
#365737 37T
#365738 38T
39
#107875
DOUBLE-SIDED TAPE
Receiver
(NOT INCLUDED)
FRONT POSITION
REAR POSITION
Speed Controller
(NOT INCLUDED)
#107876
HUDY ULTRA THIN DOUBLE-SIDED TAPE - SINGLE STRIP (5)
7. FINAL ASSEMBLY
2x
#326153
STAINLESS STEEL WEIGHT UNDER SERVO FOR 1-PIECE CHASSIS 13g
#326149
GRAPHITE PLATE FOR ELECTRONICS FOR 1-PIECE CHASSIS - SET
#326152
STAINLESS STEEL WEIGHT FOR ELECTRONICS 1-PIECE CHASSIS 30g
(Including 2pcs Hex screws 110° SFH M2x3 #913203)
(Including 4pcs Hex screws 110° SFH M2x3 #913203)
(Including 4pcs Hex screws 110° SFH M2x3 #913203)
CHASSIS TUNING
To Next Page
Loading...
