To prevent dust apply one of the included stickers on the
rear part of the chassis to cover the center balancing hole.
REMOVE ALL THE SCREWS
- Gearbox Cover Upper Screws
- Gearbox Cover Lower Screws
- Anti-roll Bar Linkage
- Shock Absorbers
Strong Tool
REMOVING THE DIFFERENTIAL WHEN CAR IS ASSEMBLED
INSTALLING THE DIFFERENTIAL WHEN CAR IS ASSEMBLED
&
&
EXTREMELY IMPORTANT
HUB MUST BE INSERTED IN
GROOVE AND PROPERLY
PRESSED INTO BULKHEAD.
"CLICK"
TIGHTEN ALL THE SCREWS
- Gearbox Cover Upper Screws
- Gearbox Cover Lower Screws
- Anti-roll Bar Linkage
- Shock Absorbers
THE COVER MUST BE ALIGNED WITH LABYRINTH
GROOVE AND THEN PRESSED INTO PLACE
Check that left and right Diff
Height Inserts are installed in
the same orientation.
To Previous Page
Loading...
