10
2. FRONT TRANSMISSION
980314
P 3x14
Graphite Grease
(HUDY #106210)
Apply oil from inside to prevent
breakage of the rubber boot.
85mm - SHORT CVD DRIVE SHAFT
BEFORE inserting the clip on the central CVD shaft joint, apply a small amount of
threadlock on the area where the clip goes.
AFTER inserting the clip on the central CVD shaft joint, turn the clip so that the slot is 90°
from the pin. This will prevent the pin from opening the clip.
➊
➋
➌
➍
DETAIL
352006 DIFF BULKHEAD BLOCK SET FRONT/REAR
355114 BEVEL DRIVE GEAR 14T
355236 CVD DRIVE SHAFT COUPLING - HUDY SPRING STEEL™
355416 CENTRAL CVD SHAFT UNIVERSAL JOINT - HUDY SPRING STEEL™
355427 FRONT CENTRAL CVD DRIVE SHAFT 85MM - HUDY SPRING STEEL™
355471 DRIVE SHAFT LOCKING RING (2)
355472 DRIVE SHAFT BOOT (2)
901404 HEX SCREW SB M4x4 (10)
908312 HEX SCREW SOCKET HEAD CAP SCH M3x12 (10)
930816 BALL-BEARING 8x16x5 STEEL SEALED - GREASE (2)
980314 PIN 3x14 (10)
355005 DIFFERENTIAL 46T - V2 - SET
BAG
➎
355005
908312
PIN
STEP DETAIL
➍
The ring can be assembled by hand,
but for easy disassembly we recommend
using snap ring pliers (HUDY #189040).
355472
355471
(85mm)
355427
355236
355416
352006
355114
352006
980314
901404
930816
930816
OIL
NOTE
ORIENTATION
XRAY BALL-BEARING
#930816 8x16x5 GREASE STEEL INCLUDED
#930817 8x16x5 OIL STEEL OPTION
#355415 CENTRAL DOGBONE SHAFT UNIVERSAL JOINT - HUDY SPRING STEEL™
#355432 FRONT CENTRAL DOGBONE DRIVE SHAFT 85MM - HUDY SPRING STEEL™
To Next Page
Loading...
