Xray XB8E'21 - 2. REAR TRANSMISSION; XRAY BALL-BEARING; Graphite Grease; TIP BEFORE inserting the clip...

12
2. REAR TRANSMISSION
980314
P 3x14
Graphite Grease
(HUDY #106210)
Apply oil from inside to prevent
breakage of the rubber boot.
BEFORE inserting the clip on the central CVD shaft joint, apply a small amount of
threadlock on the area where the clip goes.
AFTER inserting the clip on the central CVD shaft joint, turn the clip so that the slot is 90°
from the pin. This will prevent the pin from opening the clip.
115mm - LONG CVD DRIVE SHAFT
BAG
352006 DIFF BULKHEAD BLOCK SET FRONT/REAR
353053 ALU REAR SHOCK TOWER - CNC MACHINED 7075 T6 (4MM)
355114 BEVEL DRIVE GEAR 14T
355236 CVD DRIVE SHAFT COUPLING - HUDY SPRING STEEL™
355416 CENTRAL CVD SHAFT UNIVERSAL JOINT - HUDY SPRING STEEL™
355627 REAR CENTRAL CVD DRIVE SHAFT 115MM - HUDY SPRING STEEL™
355471 DRIVE SHAFT LOCKING RING (2)
355005
908312
908312
355472
355471
(115mm)
355627
355236
355416
352006
355114
352006
353053
980314
901404
930816
930816
355472 DRIVE SHAFT BOOT (2)
901404 HEX SCREW SB M4x4 (10)
908312 HEX SCREW SOCKET HEAD CAP SCH M3x12 (10)
930816 BALL-BEARING 8x16x5 RUBBER SEALED - GREASE (2)
980314 PIN 3x14 (10)
355005 DIFFERENTIAL 46T - V2 - SET
XRAY BALL-BEARING
#930816 8x16x5 GREASE STEEL INCLUDED
#930817 8x16x5 OIL STEEL OPTION
#355415 CENTRAL DOGBONE SHAFT UNIVERSAL JOINT - HUDY SPRING STEEL™+
#355632 FRONT CENTRAL DOGBONE DRIVE SHAFT 116MM - HUDY SPRING STEEL™
➊
➋
➌
➍
DETAIL
➎
PIN
STEP DETAIL
➍
The ring can be assembled by hand,
but for easy disassembly we recommend
using snap ring pliers (HUDY #189040).
OIL
NOTE
ORIENTATION