Xray XB8E'21 - 12. FINAL ASSEMBLY; Body Reamer (HUDY #107602); Ensure to make this rear body mount hole oval...; CUTTING LINE FOR SADDLE PACK LAYOUT (INITIAL SETTING)

48
Body Reamer (HUDY #107602)
➍
Before cutting and making holes on the body, put the unpainted body on the chassis to confirm the
mounting position and location for holes and cutouts.
Before painting, wash the inside of the body with mild detergent, and then rinse and dry thoroughly.
Mask all windows.
Apply paint masks as appropriate.
Paint the body using paints formulated for polycarbonate bodies.
When the paint is dry, remove the masking.
Carefully cut out the body using appropriate scissors or cutting tools.
When you have finished cutting, peel off the external protective films.
➊
➋
➌
➎
➏
➐
➑
DETAIL
To reinforce the body or to fix broken
body use #106280 HUDY BODY FIX
Ensure to make this rear body mount
hole oval so in the case of chassis flex
after a big jump the body mount will
not tear up the hole.
XB8 BODIES
#359711 HIGH-SPEED OPTION
#359712 HIGH-SPEED LIGHTWEIGHT OPTION
#359713 "EAZY" INCLUDED
#359714 "EAZY" LIGHTWEIGHT OPTION
12. FINAL ASSEMBLY
SIDE VIEW
CUTTING LINE FOR SADDLE PACK LAYOUT
CUTTING LINE FOR BRICK LAYOUT
CUTTING LINE
SIDE VIEW
INCORRECT
CORRECT
TOP VIEW
CUT
CUTTING LINE
INCORRECT
CORRECT
(INITIAL SETTING)