Switch On-Off the balance
Short press: When measure is ≤ 6g – back to zero
Long press: Enter calibration procedure
Tare – Scroll menu and number in setup
Print – Change the position in settings
Function selection (weigh – PCS counting - Percentage…)
Short press: Unit conversion
Long press: 1d / 10d conversion
Normal weighing
Preparation
• Connect the power supply.
• Press On/Off button to switch on the balance.
• Pre-heat Time
In order to ensure the precision of weighing, please preheat the balance completely reference to
technical parameter form (page 19-20), then start the following operation .
• Measure.
Example
Basic weigh operation（balance already pre-heated，
Put the container on the plate
Tare the balance (TARE key)
Put the sample in the container
To Next Page
Loading...