XS Instruments BL 224 Basic - Calibration; Function Operation; PCS Counting

5
Calibration
In order to ensure the precision of weighing, please preheat the balance completely before the calibration
Procedure
Display
1
Zero position stable
0.0000 g
2
With no load on the plate, keep pressed CAL key for 5 seconds
CAL
3
Scale value blinks for 3 seconds
200.0000 g
4
Put the correspondent external certificated weight on the plate
-------------
5
Display the calibrated valued
200.0000 g
Calibration complete
Function Operation
To choose the operating mode keep pressed MODE key for 3 seconds:
All functions are displayed, in a cycle:
Normal weighing mode
NORMAL
g
Pieces counting
COUNT
Pcs
Percentage weigh mode
PERCENT
%
Density measure mdoe
DENSITY
d
Press MODE to confirm the selection.
Density measure mode is an option, if you need please contact our company or authorized
Distributor
PCS counting
By this procedure the user measures the total weight of the certain samples which with similar single weight,
then divided by the single sample weight to get the final quantity of the sample.
Procedure
Display
1
Select COUNT mode
COUNT pcs
2
Display asks for sample number
20 pcs
3
Use Tare to select an alternative number
10, 20, 100 …
4
Put the correspondent numbers of samples on the pan
-------------
5
Press CAL to confirm the sample number
20 pcs
6
Unload the pan
0 pcs
7
Putt all your samples on the pan
167 pcs
• In Count Mode, to reset the sample number value, press MODE.
• To Exit the Count Mode: Keep pressed MODE key, and then choose the normal weigh mode.