16
QUICK-START OPERATION
1. Attach the Safety key to enable the display (if not already on).
2. Press the Start key to begin belt movement. Adjust to the desired speed using the Speed p and q
keys. You may also use the SPEED buttons 1 through 9 to adjust the speed.
3. To slow tread-belt press and hold the Speed q key to the desired speed. You may also press the
SPEED buttons 1 through 9.
4. To stop the tread-belt press the Stop key or pull away Safety key.
PAUSE/STOP/RESET FEATURE
1. When the treadmill is running the pause feature may be utilized by pressing the red Stop key once.
This will slowly decelerate the tread-belt to a stop. The Time, Distance and Calorie readings will
hold while the unit is in the pause mode. After ve minutes the display will reset and return to the
start up screen.
2. To resume your exercise, when in Pause mode, press the Start key. The speed will return to the
previous settings.
3. Pause is executed when the Stop key is pressed once. If the Stop key is pressed a second time, the
console will reset and return to the idle mode (start up) screen.
CALORIE DISPLAY
Displays the cumulative calories burned at any given time during your workout.
Note: This is only a rough guide used for comparison of different exercise sessions, which cannot be
used for medical purposes.
TO TURN TREADMILL OFF
1. Display will automatically turn off (go to sleep) after 30 minutes (no key operations). The treadmill
will draw very little current in sleep mode (about as much as your television when it is turned off).
2. Remove tether cord.
3. Turn off the main switch on the front of the treadmill, below the motor cover.
LUBE MESSAGE
When “Lube” appears on the LCD check lubrication under walking deck. See the instructions on page
20 to add lube as needed. After application hold ENTER for 3 seconds to reset the message.
To Next Page
Loading...
Need help?
General
