4
Visit our website at http://xtm.globalhobby.com or for Customer Service at http://globalservices.globalhobby.com
●
Trinity "8 Pack" AA Alkaline batteries for the transmitter -- Part # 837801
●
Trinity "4 Pack" AA Alkaline batteries for the receiver -- Part # 837800
●
Trinity "Final Solution" after-run oil to "wet" the air filter and to lubricate the engine -- Part # 843744
●
Emerald Nitro Car Cleaner to clean the chassis and engine -- Part # 340196
●
Small, flat blade screwdriver to make engine adjustments -- Part # 146101
●
Adjustable wrench and other assorted tools to make chassis adjustments
●
1.5mm hex wrench to make brake and 2-speed transmission adjustments
●
Assorted weights of silicone shock oil to tune the shocks and differentials - Optional
Each radio system comes with stickers on the back of the transmitter and on the receiver showing which frequency the radio system
operates on (either in the 27Mhz or 75Mhz band). No two radio systems can operate nearby each other if they are on the same
frequency. You can purchase transmitter and receiver crystals separately and change them if you plan on running your Mammoth RTR
Nitro Monster Truck with other people. We have provided a list of the frequencies that are available for your radio system.
SECTION 2: OTHER RECOMMENDED ITEMS
SECTION 3: BECOMING FAMILIAR WITH YOUR MAMMOTH RTR NITRO MONSTER TRUCK
Antenna: Transmits the signal from the transmitter to the receiver. The antenna should be completely extended during use.
Battery Cover: This cover houses the 8 AA Alkaline batteries that power the transmitter.
Crystal: This is the frequency crystal of the transmitter. You can change crystals in both the transmitter and the receiver (in the chassis) so that you
and your friends can drive at the same time. No two radio systems nearby can be operated on the same frequency.
On-Off Switch: Turns the transmitter on and off. Two L.E.D.s show the power of the batteries.
Servo Reversing Switches: Allow you to quickly and easily change the direction the servos rotate by just flipping the switches on the top
of the transmitter.
Steering Wheel: Controls the Mammoth RTR Nitro Monster Truck's steering. Turn the wheel to the right and the truck turns right. Turn the wheel to
the left and the truck turns left.
Throttle/Brake Trigger: Controls the speed and braking ability of your Mammoth RTR Nitro Monster Truck. Pull the trigger to accelerate, release
the trigger to decelerate, and push the trigger to brake.
Trim Levers: These levers, one for steering and one for throttle/brake control, allow you to fine tune the servo's center by sliding the levers on the
transmitter back and forth.
Channel # Frequency Part # (tx/rx)
67427xx/66427xx
01 16.995
02 27.045
03 27.095
04 27.145
05 27.195
06 27.255
61 75.410
90 75.990
Through
67475xx/66475xx
Note that "xx" is the actual channel number
you want to purchase.
27Mhz
75Mhz
To Next Page
Loading...
