EPB Reset
SAS Adjust
DPF Regeneration
Throttle Relearn
IMMO Service
Service/Maintenance Light Reset
：
The lightening of the car maintenance
light indicates that the vehicle needs maintenance.Reset the mileage or driving
time to zero after the maintenance, so the maintenance light will go out and the
system will start a new maintenance cycle.
EPB Reset
：
This function has a multitude of usages to maintain the electronic
braking system safely and effectively. The applications include deactivating
and activating the brake control system, assisting with brake fluid control,
opening and closing brake pads, and setting brakes after disc or pad
replacement, etc.
SAS Adjust
：
To reset the steering angle, first find the relative zero point
position for the car to drive in straight line.Taking this position as reference,the
ECU can calculate the accurate angle for left and right steering.
DPF Regeneration
：
DPF regeneration is used to clear PM(Particulate Matter)
from the DPF filter through continuous combustion oxidation mode (such as
high temperature heating combustion, fuel additive or catalyst reduce PM
ignition combustion) to stabilize the filter performance.
Throttle Relearn
：
Elec. Throttle Adaption is to utilize the car decoder to
initialize the throttle actuator so that the learning value of the ECU returns to
the initial state.
IMMO Service
：
To prevent the car being used by unauthorized keys, the
anti-theft key matching function must be performed so that the immobilizer
control system on the car identifies and authorizes remote control keys to
normally use the car.
6. Settings
Select the Settings application to open a setup screen to adjust the default
setting and view information about the Anyscan A30 system. There are 5
system settings.
Language: Tap to select the language you need.
To Next Page
Loading...
