Please read this user manual carefully before using this Smart Diagnostic System, referred to as the “Scan Tool” throughout
this document. When reading the manual, please pay attention to the words “Note” or “Caution”, and read them carefully for
appropriate operation.
For safe operation, please follow the instructions below:
Keep the device away from heat or fumes when in use.
If the vehicle battery contains acid, please keep your hands and skin or fire sources away from the battery during
testing.
The exhaust gas of the vehicle contains harmful chemicals. Please ensure adequate ventilation.
Do not touch the vehicle cooling system components or exhaust manifolds when the engine is running due to the high
temperatures reached.
Make sure the car is securely parked, Neutral is selected or the selector is at the P or N position to prevent the vehicle
from moving when the engine starts.
Make sure the (DLC) Diagnostic Link Connector is functioning properly before starting the test to avoid damage to the
Diagnostic Computer.
Do not switch off the power or unplug the connectors during testing. Doing so may damage the ECU (Electronic
Control Unit) and/or the Diagnostic Computer.
Avoid shaking, dropping or dismantling the scan tool as it may damage the internal components.
Use only your fingertips to touch the LCD screen. Hard or sharp objects may damage the scan tool.
Do not use excessive force;
Do not expose the screen to strong sunlight for a long period.
Please keep the scan tool away from water and moisture.
Store and use the scan tool only within the temperature ranges identified in the Technical Specifications section.
Keep the unit away from strong magnetic fields.
To Next Page
Loading...
