And then please enter the sub-menu by the origin region of car make and select the vehicle model you need
TPMS reset can be further divided into 4 methods, such as Automatic Relearn, Static Relearn, Copy ID and OBD Relearn,
which is depending on the specific model. Also, even if the relearning methods are the same, the learning procedure may
differ.
Install tire pressure sensor appropriately
Adjust all TPMS sensors to the standard value
Keep the vehicle at a complete standstill status for more than 20 minutes (with the engine off and power off)
Drive at 30-100km/h for more than 15 minutes
The vehicle will automatically relearn the value, after that, the tire pressure warning will disappear
If the relearn procedure fails, please repeat steps 2-5
Install all tire pressure sensors appropriately
Pull up the parking brake
Turn the ignition to ON/RUN with the engine off
Enter the tire pressure learning mode through the instrument panel on vehicle. There will be the corresponding prompt,
which are differ from different car make and model, please subject to the vehicle manual or consult a professional)
Starting from the left front wheel (some models flash the turn signal at the corresponding position), use the TPMS
Activation Tool to activate the sensor, and the vehicle will sound the horn or flash the turn signal at the corresponding
position after successful activation.
! Note: The first sensor should be learned within 2 minutes, otherwise please repeat step 4
After the left front wheel sensor is successfully relearned. For the remaining, please activate the remaining tire pressure
sensors in the order of right front, right rear and left rear. The prompt and activation success status are the same as
step 5
To Next Page
Loading...
