Xtralis VESDA
®
Xtralis VESDA LCD Programmer Product Guide
www.xtralis.com 39
130. Communications - The Communications screen allows settings for:
• Net Delay - This function sets the maximum time for a message to travel around
the network and return to the originating device. If the message does not return
within the prescribed time, it is presumed lost and will be resent
• Pref. Port - This allows you to assign a preferred port for communication
• Health Check - This function sets the frequency of health-check messages sent
around the system
• Open-ended - In an open ended VESDAnet loop select the port that is not
connected to the VESDAnet loop.
DST
131. Miscellaneous -
• UL Version - A against this indicates that the device is set to meet UL
specifications.
• Def. User - Sets the chosen user as default (the first to appear when logging on)
• Support - Displays the contact phone number for support
• Latch Alarms - This provides a YES/NO option to latch/unlatch all Alarms
• Latch Faults - This provides a YES/NO option to latch/unlatch all Faults
ADM
ADM
DST
ADM
ADM
132. HLI - Select the HLI and press . USR
133. Status - Displays the current status for:
• Faults - Lists faults for the HLI
• SW Version - Displays the software version of the HLI
• Cfg Code - This is a configuration code set during production
• Sub-Node Type - Informs the type of HLI connected to VESDAnet
USR
134. Location - Allocate a VESDA Zone name and location and assign these to the
LCD Programmer.
ADM
135. Power Supply Number - Input the number of the power supply that is assigned to
the detector. If the VESDA Intelligent Power Supply is not being used enter “0”.
ADM
136. Factory Defaults -
• Factory Defaults - To restore factory defaults, highlight Restore and press .
• Defaults OK - Highlighting Start and pressing will acknowledge Factory
Default settings and clear faults 12, 30, 31, 33, 34, 35, 38, 57, 68 and 72.
DST
ADM
137. Communications - The Communications screen allows settings for:
• Net Delay - This function sets the maximum time for a message to travel around
the network and return to the originating device. If the message does not return
within the prescribed time, it is presumed lost and will be resent
• Pref. Port - This allows you to assign a preferred port for communication
• Health Check - This function sets the frequency of health-check messages sent
around the system
• Open-ended - In an open ended VESDAnet loop select the port that is not
connected to the VESDAnet loop.
DST
138. Setup By Type - The Setup By Type selection allows accessing and managing the
properties of all Xtralis VESDA devices connected to VESDAnet. This screen lists
all the Xtralis VESDA products connected to the VESDAnet. Highlight the required
product and press .
USR
Scrn
No.
Description
Min.
Access
Level
↵
↵
↵
↵
To Next Page
Loading...