11
Chapter 4 Instructions of operation, maintenance and
troubleshooting
4.1 Operation sequence:
4.1.1 Press power switch, then the indicator of the display screen is lit.
4.1.2 Press “memory release” key, then the display screen starts flashing.
4.1.3 Press “↑” or “↓” to input set number and time.
4.1.4, Then, press “Memory input” key to set program. After that, start packaging process.
4.1.5 If you want to start packaging process after setting, press start button to proceed it. Then,
the upper lid will automatically open and swing to another side. If it’s necessary to stop
or change program memory function during vacuum or sealing process, press E-stop
key (L) to achieve it. Only press the upper lid will re-start the normal process.
※Attention: keep hands away from the packaging area.
4.1.6 single/auto mode switch: If you want to use single packaging mode, turn the single/auto
mode switch (G-6) to single mode. Then, press start button for single packaging process.
If you want to use auto packaging mode, turn the single/auto mode switch to auto mode.
Then, press start button for auto process. If you want to stop packaging, press “stop
button” to stop it.
※Attention: keep hands away from the packaging area during auto mode.
To Next Page
Loading...