Xtrem Bots SMART BOT - Batteries Installation; Start the Smart Bot

6
3. batteries installation
in the transmitter
in the robot
Robot ba ery is into the back of the Smart Bot.
To charge Li-Po ba ery, please insert the USB port provided USB
charging cable to anyone USB port of power pack, mobile charger, car
charger or computer.
Switch OFF the robot before charging. A light in the robot will be
turned on during the chargins process; when the robot is fully charged
the light will turn o .
The charging  me is about 2 hours and the playing  me is about 3
hours.
4. start the Smart Bot
Switch on the ON/OFF bu on on the front of the Smart Bot (1).
The Smart Bot introduce himself performing some movements and
sounds.
NOTE: The robot should stay on the  oor.
1. Use a philips’ head screw to open the bu on cell gate of controller.
2. Put 2 x 1.5V “AA” ba eries inside the ba ery box.
3. Put the gate back and use a screw to  ghten the gate.
(1)