OPERATION
3
How to replace CFT
Step 1. Turn off the power to the pump and
chlorine salt generator. Ideally this should be
done at the circuit breaker. The controller display
should go blank.
Step 2. Relieve the water pressure at the relief valve,
it is usually on top of your pool lter.
Step 3. Unscrew the threads on both sides of
the original T cell.
Step 4. Original AquaRite Turbo Cell out from the
piping.
Step 5. Pull the plug out at the lower corner
of the digital controller.
Step 6. Inspect the O-rings inside the union
connected with the pipe for any wear and replace
them if possible. Apply a thin layer of lubricant to the
O-ring.
To Next Page
