GENERAL INSTRUCTION
The chlorine generator is an automatic chlorine generation system for pool sanitation. The operation requires
a low concentration of salt (sodium chloride) in the pool water. The chlorine generator automatically sanitizes
your pool by converting the salt into free chlorine which kills bacteria and algae in the water. Chlorine will
revert back to sodium chloride after killing bacteria. These reactions will continuously recycle virtually
eliminating the need to add sanitizing chemicals to your pool.
To extend the service life, please ensure that the equipment operates in the following status
Temperature Range:
The chlorine generator normally works in the pool temperature range of 11℃˜ 45℃. Once it's exceeded, the
chlorine generator will alarm and stop until the water temperature returns to the normal range (see
TROUBLESHOOTING description for details).
Water Flow Range:
Different salt chlorinators have different requests for the water flow. Make sure that the water flows through
the salt cell in the correct direction and install the pipe on the back of chlorine generator, to ensure that the
titanium kits completely soaked in water. Please refer to Installation Instructions on how to install chlorine
generator.
Please read the following table for the flow required for different chlorinators.
Types
I
nstallation
D
irection
M
in.waterflowto
s
tart(m3/h)
W
aterflowwillstopthe
m
achine(m3/h)
Externalflowswitch
Horizontal 2
1.2
Vertical 2
1.2
Salinity Range:
The chlorine generator normally works at a salinity of 1700PPM˜4500PPM. Once it's exceeded, the chlorine
generator will stop until the pool water is back within this range.
2
To Next Page
Loading...