XtremepowerUS 90151 - LED Display Screen Meanings; Daily Usage and Maintenance; Salinity Regulation

Contents for the LED screen
Displaycharacter Meaning Displaycharacter Meaning
Thechlorinegeneratoris
open
Currentsalinitylevel(ppm)
Thechlorinegeneratoris
closed
Currentwatertemperature
detected,thedefaultis℃,
Automaticcleaningmode
setting,thenumber
representstheself-cleaning
intervalhour
Erroralarmandthe
correspondingerrorlightis
inred
Thechlorinegeneratorisinsuspension
Thechlorinegeneratoralternatesbetweenchlorinationproducingandsuspension,andtakes
onehourasacycle.Forexample,whenitis60%,thereare36minutesinchlorination
producingstatus,andtherest24minutesareinsuspension.
DAILYUSAGEANDMAINTENANCE
Salinity regulation
The salt in the pool is constantly recycled and the loss of salt is smaller than during the entire
swimming season. This loss is mainly due to splashing, backwashing, or drainage (due to
rain). Salt will not be lost in evaporation. Ideal salt levels range from 2.7 g/L (2700 PPM) to
3.4 g/L (3400 PPM)
High salt will probably give you a salty taste of pool (normally, at a level of 3.5g/ (3500 PPM)
-4 g/L (4000 PPM) you will taste salty) when the salinity of chlorine generator is higher than
4800PPM, the chlorine generator will stop (see ERR4 fault), please replace part of the pool
water. Low salt level will reduce the chlorine producing efficiency. When the salinity is lower
than 1.7g/L (1700 PPM), t he chlorine generator will stop (refer to ERR2 fault). At this time,
add salt according to the recommended volume given in the table below.
6