XTZ 99.38 - Connection and Operation

Page: 9
Mounting and Connecting tips
Mounting
alternatives
Normally the XTZ 99.38
is placed standing by a
wall. The wall
behind and besides the loudspeaker
have influence both on the
bass level and the bass
characteristics, so please be patient and
try
different distances to the rear and side walls.
Connect using the
correct phase
Always connect using the correct phase, from the
+-pole on the amplifier to the +-
pole on the
loudspeaker and corresponding for minus (-).
If you by accident connect the other way,
there is no risk of damage.
However, the
sound will not be correct, especially in the
lower frequencies.
Overload
At high load during extensive time periods, there is
always the risk of overloading the driver and
amplifier.
All loudspeakers have a limited patience
for high po
wer, so be careful not to play
extremely loud and not to increase treble
or bass settings to much.
By increasing the bass or treble from 0 to
max you will increase the power by about
16 times.
The initial playing
time
It takes about 50 to 100 hour of
initial playing time,
for the driver to sound optimal. During this time,
the speaker may be used normally.