XTZ 99 W10.16 User Manual

Mounting
Mounting
The XTZ 99 W10.16
is best placed standing on the
floor.
However it is fully possible to lay it down
without affecting the sound.
Driver and bass reflex gates should not be faced
towards floor or wall; they need to "breathe" freely.
Spikes
99 W10.16 has feet of rubber t
o absorb vibrations.
It’s possible to change this to spikes.
M6 Screws size is used
Connect with the
correct phase
Always connect using the correct phase, from the
+-pole on the amplifier to the +-
pole on the
loudspeaker and respectively for the minus (-)
pole.
If connectio
n with Line in is used, only one of the
connectors needs to be used.
If both of the connectors are used, the output level
are 3dB higher
If you by accident connect the other way,
there is no risk of damage. However, the
phase of the signal will be not co
rrect,
resulting in improper sound.
Overload
Avoid playing very loud for longer periods of time.
This causes higher stress on the amplifier and
drivers.
If you play extremely loud for a long time
there is a big risk that you destroy the
product.
The initial playing
time
It takes about 50 to 100 hour of initial playing time,
for the driver to sound optimally
. During this time,
the speaker may be used normally.
Amplifiers with low
level output to XTZ
W10.16 Line In
Connect either a st
ereo or mono RCA lead to your
output device (surround decoder, TV, stereo
receiver, etc) depending on whether a stereo or
mono output is provided.
If stereo, connect both RCA plugs into the
subwoofer's RCA jacks. If mono, connect the RCA
plug into either of the input jacks.
Then connect the
power cord to your power outlet.

XTZ 99 W10.16 Specifications

General

Brand	XTZ
Model	99 W10.16
Category	Subwoofer
Language	English