Need help?Do you have a question about the XTZ 99 W12 DSP and is the answer not in the manual?
General| Type | Active Subwoofer |
|---|---|
| Driver Size | 12 inches |
| Power Output | 500 W RMS |
| DSP | Yes |
| Crossover Frequency | 40 - 150 Hz |
| Inputs | RCA, XLR |
| Phase Adjustment | 0-180 degrees |
Explains the benefits of DSP for sound quality in different rooms.
Explains the DSP module, converters, and software capabilities.
Details how subwoofer placement affects frequency response and sound.
Explains placement freedom and the "DELAY" function for phase alignment.
Warns about potential damage from high power load and DSP adjustment.
Lists and describes the numbered controls and connectors on the rear panel.
How to use Graphical and Parametric Equalizers for sound adjustment.
Detailed steps for setting Input Gain to maximize level without clipping.
Covers the graphical equalizer with 10 bands for sound character adjustment.
Explains using subsonic filter to reduce noise, distortion, and control bass.
OUTPUT / Polarity setting (Negative or Positive) for phase alignment.
OUTPUT / Phase adjustment (0-180 degrees) for crossover frequency alignment.
Explains the order and importance of setting high-cut, polarity, and phase.
OUTPUT / Delay adjustment for time alignment with main speakers.
Steps to measure distances and set time delay to avoid phase problems.
Introduces the parametric equalizer with 5 bands (PEQ 1-5).
PEQ 1 - Frequency: Setting the center frequency for EQ band 1 (16-250Hz).
PEQ 1 - Amplitude: Adjusting boost or cut for EQ band 1 (+12dB to -12dB).
PEQ 1 - Q Factor: Adjusting filter bandwidth for EQ band 1 (0.5-50).
Explains PEQ parameters (Frequency, Amplitude, Q-factor) for precise sound balancing.
Important warnings about sound pressure levels and electrical shock risks.
To Next Page
