2
DESCRIPTION OF SYMBOLS
Read instruction manual
Do not put in the rubbish
Wear eye, breathing and hearing
protection
Double insulated
Volts
Hertz
Watts
Revolutions, reciprocations or strokes
per minute
No load speed
Warning
Alternating current
V
Hz
W
/min
n
0
R.C.M. Regulatory compliance mark
CARING FOR THE
ENVIRONMENT
Power tools that are no longer usable
should not be disposed of with household
waste but in an environmentally friendly
way.
Please recycle where facilities exist.
Check with your local council authority for
recycling advice.
Recycling packaging reduces the need for
landll and raw materials.
Reuse of recycled material decreases
pollution in the environment. Please
recycle packaging where facilities
exist.
Check with your local council authority for
recycling advice.
ADDITIONAL SAFETY
WARNINGS FOR DEMOLITION
HAMMERS
WARNING! Hold power tool by
insulated gripping surfaces when
performing an operation where the
cutting accessory may contact hidden
wiring or its own cord. Cutting a ‘live’ wire may
make exposed metal parts of the power tool ‘live’ and
could give the operator an electric shock.
Safety Warnings Specic for Demolition
Hammer Operations:
a) Always use the side handle, this gives you greater
control if the accessory should become jammed.
b) Keep the cord clear of the accessory being used, do
not wrap the cord around your arm or wrist.
c) Use thick cushioned gloves and limit the exposure
time by taking frequent breaks.
d) Vibration caused by the hammer action may be
harmful to your hands and arms.
e) When removing an accessory from the tool avoid
contact with skin and use proper protective gloves
when grasping the bit or accessory. Accessories
may be hot after prolonged use.
Safety Warnings Common for Demolition
Operations:
a) Always wear eye protection and a dust
mask for dusty applications and when
sanding overhead. Sanding particles can be
absorbed by your eyes and inhaled easily and may
cause health complications.
b) Wear ear protectors. Exposure to noise can
cause hearing loss.
c) Use auxiliary handle(s), if supplied with
the tool. Loss of control can cause personal
injury.
d) Always use an approved extension lead suitable
for the power input of this tool. Before use, inspect
the extension lead for signs of damage, wear and
ageing. Replace the extension lead if damaged or
defective.
e) When using an extension lead on a reel, always
unwind the lead completely. Use of an extension
lead not suitable for the power input of the tool or
which is damaged or defective may result in a risk
of re and electric shock.
f) It is recommended that the extension lead is a
maximum of 25m in length. Do Not use multiple
extension leads.
g) Before drilling into walls, ceilings etc, ensure there
are no concealed power cables or pipes in the
cavity.
•
WARNING! Some dust created by power
sanding, sawing, grinding, drilling and other
construction activities contain chemicals
known to cause cancer, birth defects or other
reproductive harm.
Some examples of these chemicals are:
• Lead from lead-based paints;
• Crystalline silica from bricks, cement and
other masonry products, and;
• Arsenic and chromium from chemically-
treated timber.
The risk from such exposures vary
depending on how often you do this type
of work. To reduce your exposure to these
chemicals; work in a well ventilated area,
and work with approved safety equipment,
such as those dust masks that are
specically designed to lter out microscopic
particles.
This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the appliance by a person
responsible for their safety.
Young children should be supervised to
ensure that they do not play with the appliance.
To Previous Page
Loading...
Need help?
General