3. Select Activate.
4. Select the monitoring channels for the four relays on the module.
5. Select the Action priority for each relay, that is, if the relay communicates an A-alarm or
a B-alarm on the specified monitoring channel.
6. Repeat the settings for all the connected Relay modules.
7. Click Update.
6.1.3 Set the DIP switches
1. Slits for removing the front cover
2. Switch 1–4: Relay function
3. Switch 5–8: Module address
6 System Setup
12 MRM 01 Installation, Operation, and Maintenance Manual
To Next Page
Loading...