• Make sure the cartridge is installed correctly prior to using the machine.
• For best results, turn the handle slowly.
• Arrange small items (without overlapping them) on the feed tray to
maximize your cartridge material use.
• Use items that are 1/10 of an inch thick or less.
• Test before using one-of-a-kind items.
• Watch for the “End-of-Roll” marker 18˝ from the end of Laminate and
Magnet cartridges. To remove marker, simply peel it off the laminate.
Adhesive:
• For best results, apply pressure with finger or dull tool around the
edge of the object prior to removing the clear plastic film.
• If there is excess adhesive around the edges of an item, simply wipe
off with your fingers. The adhesive comes right off without sticking to
your hands.
• Clean off adhesive buildup from the rollers with any adhesive
remover or rubbing alcohol.
Helpful Hints
To Next Page
Loading...