Yaber Y21 - Setting up Projector

SETTING UP PROJECTOR
“The projector's normal stat up screen i as follows. If the firt projection screen s not this one,
pressthe “S” button on the remote control to select USB source.
a
PHOTO MUSIC
Select the Input Source
When the "No Signal" prompt appears, you need to select the input source:
1. Press the “S” button on the remote control to select the desired signal, then press the OK
button on the remote control
2. Once the signalis detected, the selected source information will be displayed on the screen
after a few seconds.
Input Source
AV
Menu Setting Method
1.Press the “M” on the remote, then the menu picture willdisplay on screen.
2Press"/P"key, the menu will move to “PICTURE">“SOUND' >*TIME">“OPTION”.
3Select the adjust interface,use” A/ ¥ key to choose the wanted item.
4.Press"OK” or “«¢/P"to adjust the item parameter.
09